The speed should be set at the appropriate bit rate. To upload the new software Use the X loader software and check the configurations. PWM is used to power your laser and it is a vital cable for your entire machine.Īfter soldering, you can now begin configuring your software. With your board ready, identify your TTL and you can solder your TTL wires directly to your D11 Arduino and the ground. This can also mean outdated firmware that an Arduino comes with and renders it incompatible with other software. The software configuration is also very important and should be paid close attention to. It is always a good idea to check the parameters of your laser wiring to know if they are properly set up to deliver power to your laser and if they are impeded or even set up wrongly. The reason a problem arises can be from both hardware and software configurations. With proper diagnostics, it can be an easy fix for your board. Getting started with Endurance diode lasers – focusing, settings, parameters, misc Your laser will work perfectly after these instructions. With these step-by-step instructions, you will be able to configure and use your laser. There are different reasons your original firmware is not working well and we will help you solve common issues you may come across. Laser Brilliance on a Budget: New Year's Specials at Endurance Lasers – Engrave with up to 70% Off!!!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |